tag:blogger.com,1999:blog-3993498847203183398.post4608531087674082773..comments2024-03-28T09:19:27.451+00:00Comments on RevK<sup>®</sup>'s ramblings: Dissolvable PVA supportRevKhttp://www.blogger.com/profile/12369263214193333422noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-3993498847203183398.post-26186616674198481872019-10-18T09:13:07.571+01:002019-10-18T09:13:07.571+01:00I assume your first order was 1.75mm? Where was th...I assume your first order was 1.75mm? Where was that from, I've been looking to try soluble supports but everywhere I've seen the stuff it's crazily priced!!<br />rtho782https://www.blogger.com/profile/02052870855136709228noreply@blogger.comtag:blogger.com,1999:blog-3993498847203183398.post-37622994966953883962019-10-16T11:06:13.419+01:002019-10-16T11:06:13.419+01:00I used to have loads of problems with getting good...I used to have loads of problems with getting good adhesion to the print bed. Tried various tapes, PVA glue diluted with water and many other suggestions I found on the internet.<br /><br />I then discovered Printbite, just stick to your existing heated bed and print directly onto it. As soon as the bed cools down the print comes straight off. Just keep it grease free and clean with alcohol every now and then.<br />KPSGnoreply@blogger.com