2011-06-06

TARDIS

OK, it is just about possible.

This one took five and a half hours, and went slightly wrong after around five hours so a slightly off effect near the top.

But printing for that long means I have managed to solve most of the problems I think.

I'll try again when I get blue plastic.

Obviously this is a scale model - well the outside is to scale, if I tried to do the in-fill to scale I would need a lot more plastic :-)
at

1 comment:

  1. Andrew MurphyMonday, 6 June 2011 at 15:28:00 BST

    Whatever you do, don't try and print the inside!

    There isn't enough plastic in the universe...

    Also, have you thought about this?

    http://blog.makezine.com/archive/2011/06/3d-printed-house-keys.html

    ReplyDelete

Comments are moderated purely to filter out obvious spam, but it means they may not show immediately.

Subscribe to: Post Comments (Atom)

Updated regulator

I do a lot of circuits, and they all use the same basic design for power supply. OK, technically not quite, I have one for battery and one f...