2011-06-14

Still no hot end

Still can't print - this is annoying.

I do however have some aluminium. Plan is to make a hot plate around 300mm x 270mm of 8mm aluminium - and fit 25W wire wound resistors in a grid to allow me to heat it to 115C.

I have a feeling it may be too heavy for the stepper motors though.

Now to find someone that can cut 8mm aluminium, as I have 300mm x 500mm sheet here.

What fun this hobby is :-)
at

3 comments:

  1. RevKTuesday, 14 June 2011 at 11:56:00 BST

    Oh FFS, it was a public holiday in Germany yesterday - no wonder my hot end is delayed.

    ReplyDelete
  2. AnonymousTuesday, 14 June 2011 at 11:58:00 BST

    I am still snickering ever time you say "hot end".

    ReplyDelete
  3. Andrew MurphyTuesday, 14 June 2011 at 14:33:00 BST

    http://blog.makezine.com/archive/2011/06/adding-cooling-fans-to-your-3d-printer-yields-crisper-prints.html

    ReplyDelete

Comments are moderated purely to filter out obvious spam, but it means they may not show immediately.

Subscribe to: Post Comments (Atom)

Faikin Remote

We have done a lot of small PCB designs over the years, but by far the most popular is my Faikin board. Reports are that even Daikin have re...

  • It's official, ADSL works over wet string
    Broadband services are a wonderful innovation of our time, using multiple frequency  bands  (hence the name) to carry signals over wires (us...
  • Air conditioning at home (planning permission!)
    For many years I used a small stand-alone air-conditioning unit in my study (the box room in the house) and I even had a hole in the wall fo...
  • Except for access
    Drivers should be aware what road signs mean. And so they need to be clear and unambiguous. But some are a tad more challenging than others,...